News

With the widespread application of compressed air filters, more and more friends are inquiring about how to replace the filter element. Today we are writing this article to tell you how to replace the filter element. Very simple, I believe everyone will understand after reading it.

Steps for replacing precision filter element:

1. Close the system power and precision filter front and rear valves;

2. Open the drain outlet and drain the water from the precision filter;

3. Open the upper head and remove the precision filter element;

4. Rinse the inner cylinder wall of the precision filter;

5. Install the precision filter element and seal the upper head;

6. Seal the discharge outlet of the precision filter and open the front and rear valves of the precision filter.

The melt blown filter element is widely used due to its low price. The characteristic of foldable filter element is high precision, but it is expensive, so it is generally used for terminal filtration or high demand filtration. On the other hand, wire wound filter element has a certain market because it can be cleaned and reused (usually can be cleaned several times before reuse, and the number of cleaning times affects the flux and accuracy).